Workshop Pipe Saws

PolySaw1200/48

Hydraulically operated pipe saw specifically produced for the preparation of pipe segments in HDPE used for the production of bends, tees and other fabrications. Capacity 200 to 1200mm OD / 8" to 48" IPS. Cutting angle is -45 to +67.5 degrees. Lowering rate of saw is hydraulically controlled, as are the top-mounted V-clamps used to hold pipe segments in place. Saw blade made in Germany.
Low profile design allows safe, simple operation.

Technical Specifications

• Cutting range 200 to 1200mm OD.
• 67 degree maximum cutting angle allows production of segments for bends, tees and Y-branch tees.
• Hydraulic lock/release of main pipe
• Cutting feed is hydraulically controlled.
• Laser blade positioning.
• Special saw blade available for thick walled pipe.
• Angular cutting error equal to or less than 1 degree.
• Genuine 24 month international warranty.
• Speed of saw blade 250 m/min.
• - Emergency stop at operation panel.
• - All electric operating buttons and handles are operated at 24DCV.
• - Before saw blade is running，it alarms with both a flashing light and audible alarm for a few seconds.
• - Equipped with saw blade detection device. Once saw blade is broken, machine will stop immediately.
• - Saw blade guides expand and contract automatically Once pipe diameter and fitting types has been selected, assuring close contact with pipe for blade protection.
• - Saw guide travel is limited by proximity switches.
• - Pipe or fitting is locked by hydraulic controlled bar - easy, safe and reliable.
• - Low pipe bed design, providing easy and safe reception of cut pieces.
• 400 volt 3 phase 50 Hz (5.5 Kw 4.2 A). optional 480/3/60 or 220/3/60.
• Weight 7,000kg
• Please note technical specifications of Weldpoly machines may change without notice